Here 12 is the HEX command to turn ON the devices in Group 1210=I=0 Here 11 is the HEX command to turn OFF the devices in Group 1110=I=0 However it can safely be left included if you just want to change the HEX value before the Group number in the URL. Here 08 is the HEX command to Cancel linking or unlinking mode, and even though 10 for the Group is still included in the URL, it is unnecessary for a Cancel command. Here 0A is the HEX command to put the Insteon hub into Unlinking mode, and 10 is the Insteon Group it will 0A10=I=0Ĭancel Linking or Unlinking Mode (Group number doesn’t have to be included and will be ignored if it is included together with the Cancel Linking/Unlinking command). Set the hub into Unlinking mode to remove a device from Group (Scene) 10 Here 09 is the HEX command to put the Insteon hub into Linking mode, and 10 is the Insteon Group it will 0910=I=0 Set the hub into Linking mode to add a device to Group (Scene) 10 The remainder of the URL contains the commands for linking/unlinking, together with the group you want to add the device to, or the group you want to removed the device from. The guide is from the 2242-222 hub, but the commands are the same for the 2245-222 hub. You should probably download this for reference while you still can. The following are HTTP commands from the Insteon Developer Guide. Insteon Scenes will send out a single group message, where all Insteon devices in that Insteon Group (Scene) will respond simultaneously, with no popcorn effect, and no missed commands by any Insteon device that is a member of that group. You don’t have to use Insteon Scenes, but without their use you will either get a popcorn effect from your lights when you try to control several of them at once with a non-Insteon group, or some of the Insteon devices may not respond at all if you're trying to use a non-Insteon group to control multiple at once. Since you can join devices by Group (Scene) you will have the ability to add devices to your hub and to a particular Insteon Scene. But if your router doesn't display device names in the DHCP table, look for the matching MAC Address to the one shown on the bottom of your 2245-222 hub.Ġ0:0E:F3:x:x:x (where the x will be two HEX values unique to your particular Insteon hub).īefore you start, it’s important to understand some basics around how to form the URL to enable linking. If your hub has never been named, it will probably show up in a DHCP table as "Smarthome". Consult your router manual by downloading it from the manufacturer's website or do some searching online for answers using your router's brand and model number if a manual isn't available. NOTE: You will need to find your Insteon hub IP address by looking at the DCHP address table, or the MAC address table of your router. There are ways to do this with open source software, but you can also do this by using the Link button on the 2245 hub, or by using the following HTTP commands. Now that the ability to use the Insteon app is gone, you will need to manually add devices to the hub. How to add and remove devices from your Insteon 2245-222 hub
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |